15
6
Cold Boot and Line Numbering
Slide the DRL2A into the card cage, but do not fasten the
mounting screws. The DRL2A will power up and this message
will be displayed:
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
ACK:Yes CAN: No
ACK:Yes CAN: No
ACK:Yes CAN: No
ACK:Yes CAN: No
ACK:Yes CAN: No
If the screen does not display the above, remove it from
the cage and the switch will need to be turned a little more.
Press the [Ack] button for a second located on the top right
and left side, then release to perform the COLD BOOT. The
following message will be displayed. At this point the factory
default values are entered into the programming locations.
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
COLD BOOT
After approximately one second, this message will appear:
CHANGE LCARD NBR
CHANGE LCARD NBR
CHANGE LCARD NBR
CHANGE LCARD NBR
CHANGE LCARD NBR
OF
OF
OF
OF
OF
Press, for approximately one second, and release the [Ack]
button. Repeat until the desire line card number is entered.
After the line card number has been entered, press and
hold the [Ack] and [Cancel/Select] button at the same time,
until this message is displayed:
TURN OFF SWITCH
TURN OFF SWITCH
TURN OFF SWITCH
TURN OFF SWITCH
TURN OFF SWITCH
7
Turn Off Switch
The DRL2A will remain inoperative until the “Program
Enable” switch is turned OFF. To turn the switch OFF,
pull the DRL2A out of the card cage. Use again the
small screwdriver to turn the “Program Enable” switch
OFF by turning it counter-clockwise as shown on fig.4.
8
Re Install
Reinstall the DRL2A in the card cage by pushing it in all
the way in. If the message COLD BOOT re-appears on
the screen just slide the unit out again and make sure
the “Program Enable” switch is all the way to the off
position. Now you can secure the faceplate screws of
the DRL2A.
9
Ready
The DRL2A is now ready for operation under the factory
default configuration. You should now compare the default
settings and your back up setting to see if any location(s)
need to be programmed. The easiest way is to print the
default configuration on one of these DRL2A and compare
them. All the instructions on how to program the line
card can be found in the manual. However, if you have
any questions or difficulties please feel free to contact
the Sur-Gard Technical Support Department.
