5
Electrical installation
Hybrid ABOX "MTA...-S61.-...-00"
Operating Instructions – MOVIFIT
®
MC
75
5.8.3
Plug connector positions
NOTICE
The RJ45 socket can be damaged by inserting commercially available RJ45 patch
cables without push-pull connector housing.
Damage to the RJ45 socket.
• Only plug suitable push-pull RJ45 mating connectors according to IEC PAS
61076-3-117 into push-pull RJ45 sockets.
• Never use commercially available RJ45 patch cables without push-pull connector
housing. These plug connectors do not snap in place when they are plugged.
They may damage the socket and are therefore not suited.
The following figure shows the plug connectors of the hybrid ABOX:
[3] X21 – X24
[3] X25 – X28
[4] X50
[1]
X11
[2]
X12
9007202824956043
[1] X11
Ethernet interface, port
1(PROFINET IO, EtherNet/IP™,
Modbus/TCP)
(Push-pull RJ45, female)
[2] X12
Ethernet interface, port
2(PROFINET IO, EtherNet/IP™,
Modbus/TCP)
(Push-pull RJ45, female)
[3] X21 – X28 Digital inputs/outputs
(M12, 5-pole, female, A-coded)
[4] X50
Diagnostic interface
(RJ10, female, under the screw
plug)
INFORMATION
• The built-in M12 plug connectors have no specific alignment. This is why you
should only use straight M12 mating connectors.
• You find the pin assignment of the plug connectors in the "Electrical Connections"
chapter.
• To connect 2 sensors/actuators with an M12 plug connector, use the Y adapter
with extension cable, see chapter "Y adapter" (
19484828/EN – 01/2015
