SEW-Eurodrive MOVIPRO PHC2 Series, Руководство по эксплуатации, Страница: 54 / 188

5
Mechanical installation
Assembly
Operating Instructions – MOVIPRO
®
PHC2.A-A..M1-E45C-C5
54
Mounting the device
You can attach the device to the mounting surface from the front (A) or from the back
(B). The mounting type (A) is not possible if you use the handles. If the device is sub-
ject to vibration or shock loads during use, store the device on suitable rubber buffers.
The following figure provides an overview on the mounting of the device:
X1
Y1
Y2
X2
A
X1
Y1
Y2
X2
B
[1]
[2]
[3]
[4]
32462270475
[1] Mounting surface, e.g. mounting plate
[2] Mounting elements, e.g. washers
[3] Locking elements, e.g. lock washers
[4] Mounting elements, M6 or M8 screws
X
1
, Y
1
Device dimensions
X
2
, Y
2
Bore dimensions
Procedure
ü
For the housing dimensions X
1
and Y
2
, refer to the dimension drawings in chapter
"Technical data" (→
2
164).
ü The bore dimension X
2
for the tapped holes and through bores in the holding fix-
ture can be derived from the housing dimension X
1
‑ 30 mm.
ü
The bore dimension Y
2
for the tapped holes and through bores in the holding fix-
ture can be derived from the housing dimension Y
1
‑ 30 mm.
1. Mark the bores on the mounting surface [1].
2. Drill the tapped holes ( A ) and the through bores ( B ).
3. Screw the device onto the mounting surface [1] using either M6 screws ( A ) or M8
screws ( B ).
26596598/EN – 10/2020