SEW-Eurodrive 18982093, Руководство по эксплуатации

Страница: 10 / 36

2
Safety notes
Startup and operation
Operating Instructions – MOVI4R-U
®
Frequency Inverter Module
10
Ground connections are required as preventive measures.
2.7 Startup and operation
Before startup, make sure that the 4 mm sockets, buttons, and switches are intact.
It might be necessary to equip locations where such devices are used with additional
monitoring and protection devices in accordance with the respective applicable safety
regulations, e.g. the law governing technical equipment, accident prevention regula-
tions, etc.
Depending on the degree of protection, products may have live, uninsulated, and
sometimes moving or rotating parts, as well as hot surfaces during operation.
Cover unused connections with the supplied protection caps during operation.
Make sure the connection boxes are closed and screwed before connecting the sup-
ply voltage.
When the device is switched on, dangerous voltages are present at all power connec-
tions as well as at any connected cables and terminals. This also applies even when
the product is inhibited and the motor is at standstill.
Electric shock due to moving the device while voltage is applied. Do not move the
product while voltage is applied.
Do not separate the connection to the product during operation. This may result in
dangerous electric arcs damaging the product.
If you disconnect the product from the voltage supply, do not touch any live compon-
ents or power connections because capacitors might still be charged. Observe the fol-
lowing minimum switch-off time:
10 minutes.
Observe the corresponding information signs on the product.
The fact that the operation LED and other display elements are no longer illuminated
does not indicate that the product has been disconnected from the supply system and
no longer carries any voltage.
Mechanical blocking or internal protective functions of the product can cause a motor
standstill. Eliminating the cause of the problem or performing a reset may result in the
drive restarting automatically. If, for safety reasons, this is not permitted for the drive-
controlled machine, first disconnect the product from the supply system and then start
troubleshooting.
2.8 Inspection and maintenance
Only perform maintenance and repair work once the product has been secured and
disconnected from the power supply. Ensure a de-energized state of the product be-
fore you start working on it. Ensure a de-energized state for the entire time you work
on the product.
Repair work may only be carried out by SEW‑EURODRIVE.
28520688/EN – 12/2018