With your HS16 you can adjust all Servonaut
modules with the DisplayCARD function by ra-
dio. This only works if you use the Servonaut
receiver Zwo4RX9.
Connect the module you want to adjust to
one of the first 8 channels of your RX9.
You can adjust the available settings with your
HS16. Press [Menu] > [Receiver] > [CARD]
With the blue button [1v4] you get to the second
page. There you see the eight channels of the
RX9.
Use the DisplayCARD function only in
short distance to your model. Place the
model carefully so that errors of the drive
or servos can’t cause harm.
With the yellow button [SCAN] you can scan all
channels for modules with DisplayCARD func-
tion. If modules from other manufacturers or ser-
vos are connected you can deactivate the scan
for these channels - just press the channel but-
ton. Your radio shows “- - -” instead of the name
for all deselected channels.
If channel 7 or channel 8 is set as a multichannel
it is excluded from the scan automatically.
After the scan your HS16 shows the name of all
detected modules. Channels that were deactivat-
ed and channels without a connected module
are shown with “- - -”.
If you select a channel with connected Display-
CARD module you get to the DisplayCARD
menu for this module. Since HS16 and module
communicate by radio you can adjust the set-
tings and directly test them.
Tip: For testing purposes switch the con-
trols you use to the joystick and back after
you finish adjusting.
The functions for the slave receiver and its con-
nected modules are on page 3 and 4 of the Dis-
playCARD menu: [Menu] > [Receiver] > [CARD]
> [1v4].
20. Your notes
18. DisplayCARD by radio
D
D
isplay
isplay
CARD