[Swap channel]
With the servo swap you can
swap two
connections at the receiver.
All functions
and adjustments for these channels are
swapped as well. The channel numbers
remain. For example servo channel 3 is
always the third output at the receiver.
It is possible to swap two channels of a
multiswitch or a channel of the multiswitch
with a normal channel. There may be a lag
because the multi channels work a little
slower.
[Copy control]
With the control copy you can copy all
settings for one control to another one. If
you want to control a function in your model
two ways e.g. one time with big deflection
and one time with small deflection (dual
rate), you can copy the control with [Control
copy] to the second level. Adjust the settings
and switch between the two with the level
switches.
[Swap control]
Here you can swap the function of two
controls. Useful to adjust the assignment of
softkeys or to temporarily assign a function
to a joystick. Even if you swap a joystick with
a softkey pair all settings remain.
Caution:
If you didn’t assign names
to the controls the default names
don’t change after a control swap because
the softkeys are numbered serially with
Control 7, Control 8 etc. The settings still
change though.
Main Menu
21
[DisplayCARD]
Activates the DisplayCARD Mode. In this
mode you can program Servonaut modules
that are connected with your HS16 via the
DisplayCARD cable. You can recognize
these modules by the logo.
To program the module just connect it with
your radio and start the DisplayCARD
Menu. Press one of the middle or lower
buttons on the right to choose the settings.
Caution:
In the DisplayCARD Mode
all radio connections to the models
are deactivated. If you quit the menu they
are active again.
Please note: You can use any servo cable
as a DisplayCARD cable as long as the red
wire is removed from at least one of the
plugs.
D
D
isplay
isplay
CARD