Menu Control
29
faster or slower. The speed is also
affected by the value for [Runtime].
Ÿ
Softkey pair: The value changes with
each key stroke, the speed is affected
by the value for [Runtime].
Control type [Slider <-0->]
Typical use:
Swivel drives with middle
position
Same as the Hydraulic simulation [Slider
<--->
] but it stops in the middle position at
0%. Release and actuate the control again
to get beyond that point.
Control type [Slider 0--->]
Typical use: Adjust the idle speed of a
hydraulic pump manually
Ÿ
Joysticks: Not useful
Ÿ
Softkey pair: function like with control
type [Slider <--->] but the left stop is
equivalent to the middle position at the
servo output.
To use with a pump: If the softkey pair is all
to the left the pump gets a neutral impulse,
it is in the off-position.
Ÿ
Joysticks: Shortly actuating to one side
switches the control to -100%, again to
0%. Move it to the other side to set it to
100%.
Ÿ
Softkey pair: Shortly press the left key to
set the control to -100%. Press again to
set it to 0. Hold the right key to get
+100%. Press [Reverse] to swap the
function of both keys - Pushbutton left,
Switch right.
Control type [Emerg off]
Typical use:
Immediately switches off
a
internal combustion engine, a hydraulic
pump or model drive
The control has two positions: Normal and
Emergency off. In the Emergency off posi-
tion the control affects up to three servo
channels, different for each channel type.
See chapter Mixer Functions
Ÿ
Joysticks: Not useful
Ÿ
Softkey pair: Press the right key shortly
for an Emergency off, all drives stop and
are blocked. The left key lifts the
blocking.
Control type [Slider <--->]
Typical use:
Hydraulic simulation
,
swivel
drives
of any kind e.g. lowering a ramp,
adjusting volume or idle speed, trim
With this control type you can move a servo
like it was a hydraulic cylinder moved by a
valve. The control works proportionally
without steps even if you use a softkey pair.
Ÿ
Joysticks: Depending on how big the
deflection is the control value changes
Control type [Switch - +]
Typical use: Fifth wheel lock, differential lock
The control has two positions: -100% and
+100%. It simulates a switch with two posi-
tions.
Ÿ
Joysticks: Shortly actuating switches the
control to +100% or -100%.
Ÿ
Softkey pair: Press the left key to set the
control at -100%. Press the right key to
set it at +100%.
Control type [Switch 1-2-3]
Typical use: Sequential shift for
three-gear
gearbox
The control has three positions: -100% , 0%
and +100%. It simulates a sequential gear
shift.
Ÿ
Joysticks: Shortly actuating switches
one step after another from -100% to 0
to +100% and back.
Ÿ
Softkey pair: Press the right key shortly
to set the control from -100% to 0 to
+100%. Press the left key to set it back
step by step.
Control type [Switch/PushB]
Typical use: Functions of a multiswitch light
set
The control has three positions: -100% , 0%
and +100%. It simulates a switch that is a
switch in one direction and a pushbutton in
the other.