32
Menu Servo
Softkeys - different for
each channel type:
[Reverse]
Changes the direction of the servo channel
- helps to adjust that e.g. while steering the
left key [left/down] affects the deflection on
the left.
[Type]
Here you select the channel type. It deter-
mines all mixer and safety functions for the
channel.
[Left/Down]
,
[Right/Up]
, [
Trim/Center]
The maximum deflection prevents that e.g.
a servo reaches a mechanical stop and
overloads. The values for [Left/Down] and
[Right/Up] are adjustable between -150%
and +150% (Exception pump: here the
values are different). The values determine
how far the servo moves from one endpoint
to the other.
Examples:
Ÿ
A maximum control deflection of +100%
and an endpoint value of 100% equals a
servo deflection of 100%.
Ÿ
A maximum control deflection of +80%
and an endpoint value of 100% equals a
servo deflection of 80%.
Ÿ
A maximum control deflection of +100%
and an endpoint value of 120% equals a
servo deflection of 120%.
Menu buttons
[OK]
Green
Back to the higher-level menu (channel
selection).
[Test]
Yellow
Switches the test mode on/off. In test mode
a connected servo immediately reacts to a
key stroke [left, right, middle] and moves to
the position to make adjustments easier.
Caution:
If a speed controller is
connected to the channel it switches
to full throttle when in test mode. So select
the channel type [motor] for all channels
connected to an ESC to avoid damage.
There the test mode is blocked.
[Reset]
Red
First key stroke: sets all values to default
Second key stroke: changes the channel
type to [servo]
[1v2]
Blue
Shows the number of pages and turns to the
next one.
Green Button [Menu] > [Servo]
Servo channels are all the outputs of the
receiver.
Depending on which Zwo4
receiver you use there are 4, 6, 9, 12 or 16
channels available - your HS16 has 16
channel slots in the menu and always uses
the first ones. For example with a 4 channel
receiver the first 4 slots in your HS16 are
used. The channels are numbered from X1
to X16.
You can activate a multiswitch for the
channel 7 and 8.
See chapter Menu Multi-
switch.
Then the radio doesn’t show the
channel number but [MULTI 7/8]. Press
[MULTI] to select the channels of the multi-
switch. The eight multiswitch channels are
named X7a to X7h or X8a to X8h. You can
swap them as you like.
See chapter Menu
Receiver, function [Servo swap]
Hint:
The normal channels and the
channels of the multiswitch have the
same settings and even can be swapped
with each other. The multiswitch channels
react a little slower though.
Channel selection and adjustment
Select the servo channel (= channel of the
receiver) you want to adjust with [Channel
selection]. After selecting a channel you see
the first page of the channel adjustment.
10.8 Menu Servo
Servo channels, Channel type
Filled black = Test Mode on