USA
page 26
INSTALLER SECTION
2. DETERGENT DISPENSER INSTALLATION
2.1 Electrical connection
Follow the wiring diagram attached to the machine.
2.2 Water connection
a) Remove the cap from the hole and fit the delivery connection.
b) Correctly mount the injector
C
using the appropriate fixtures.
c) Connect the suction tube to the suction attachment of the dispenser (see pict. 2 - point
A
).
d) Connect the delivery tube to the other attachment of the dispenser, and the delivery fitting (see pict. 2
point
B
).
e) Insert the suction tube with filter in the detergent tank.
f) Prime the detergent and proceed to dispense.
pict. 1
A
B
C
min 1" 1/4
(3 cm)
Point B
CONNECTION DIAGRAM
pict. 2
2.3 Dispensing the detergent
The detergent dispenser capacity can be adjusted using a screwdriver
as shown in picture 1.
Every
13
/
16
inches (2 cm) of product drawn into the tube corresponds
to
1
/
64
cubic inches (0,25 cm³) equivalent to 0,01 once (0,3 g) with
a concentration of
1
/
16
once/cubic inches (1,2g/cm³). For proper
dispensing see paragraph
5.2
.
3. TECHNICAL DATA AND USEFUL INFORMATION ON PUMPS
3.1 Emptying pump
When installing, pay particular attention to the position of the emptying tube (see pict. 3).
N.B.:
To empty the tub: turn off the appliance by means of the green 0-1 (see chap.
4
), pull out the overflow
tube and leave the door open. Then keep button
5
pressed until the tub is completely empty.
During the wash/rinse cycle, excess water will automatically be drained.
MAX 31” (0,8m)
pict. 3
CAUTION: INCORRECT
POSITIONING OF THE
TUBE.
CAUTION: CORRECT
POSITIONING OF THE
TUBE.
Содержание DS 50 USA
Страница 1: ...DS 50 USA User Install Manual 3 2019...
