OmniHub 16 – User Manual
Page
76
of
112
Click the Apply button
on the right side for the changes to take effect.
Name
Range
Name
Range
QAM Mode
ANNEX A/ ANNEX B
RF level
0~63
Bandwidth
6M, 7M, 8M
Frequency (KHz)
48000~858000
Symbol Rate (KBaud)
4400~6956
Constellation
QAM16/32/64/128
/256
PSI/SI Interval (ms)
50~10000
3.3.13.3
Module Output
QAM Output will be different from the Receiver and Encoder module. Since the QAM
module is an output module like IP output, all service configured in receiver, encoder
and IP input will be seen here.
Every Channel in QAM output has Original Network ID and TS ID. It is important to
identify the TS ID properly. Labeling the TS will help you to monitor your output services.
It is also important for creating NIT for LCN and Cable Descriptors.
When you click on the Service Settings, this is the screen you will see first.
On the Left side, you will see the list of TS where there are output services. If the TS or
Channels are enabled but no Service Output, It will not be listed here.
You will also see the Original Network ID and TS ID where you can modify the details
and below will be the list of the service in the Selected TS. Initially, TS 1 is selected
when you first select the Service Configuration tab.
