OmniHub 16 – User Manual
Page
25
of
112
Click the Apply
button on the right side to make the change takes effect.
Service Configuration
tab displays the configuration page where you can manage the
received services and output them to their designated interface. Configuration steps for
IP input and all receiving and encoding modules in OmniHub 16 are mostly the same.
First, you need to
the port on each TS with LOCKED signal status. Each
port might be scanned automatically or need to be scanned when its source signal is
replaced.
After scanning each channel, you can output each transport stream or service by
clicking the icon
and
below “Destination Settings”. You can route the whole
stream or a service/s from the input channel toward the available output channel (IP or
RF). Two types of routing are possible.
1.
Bypass mode. In this mode,
routes can only be done when outputting a whole
input transport stream towards an output TS channel - this cannot be done when
outputting a single service only. Bypass mode activation will not allow other
services from other input TS to be mixed in the current TS output. Any attempts
of routing other stream/services towards this channel will result in
“this channel
won’t be available at this time”.
2.
Multiplex mode
is used to create a new SPTS or MPTS. This mode allows the
administrator to perform the following operation:
a. Routes a single service towards an output channel to create SPTS
b. Routes services towards a single output channel to create MPTS
c. Route service/s AND stream/s from multiple channels towards a single
output channel to create MPTS.
Service Configuration page interface
