OmniHub 16 – User Manual
Page
34
of
112
2. Select the correct Output and Channel you want to output the stream to.
3. Check Multiplex or Bypass on the Channel you want to output
4. Click the Apply button
on the right side to make the change takes effect.
To use
Multiplexing mode on service level,
1. Click on
(pencil) icon. There will be always a BaseBoard selection for the IP
output and other Output options depending on the modules inserted.
2. Select the correct Output and Channel you want to output the service to.
3. Check on Multiplex on the channel you want to output. You can output multiple
service in one channel or output one service to multiple channels
4. Click the Apply button
on the right side to make the change takes effect.
To clear the whole routing table click
button.
There is a channel scan button
on top,.
Normally the input service list of each channel will lshow on this page, but when you
change the input source, you should refresh the changed channels manually by
selecting the channel and clicking
Channel Scan
button.
3.3.1.5
Module System Operation
