OmniHub 16 – User Manual
Page
26
of
112
To use
Bypass
or
multiplex mode on stream level
, click the icon
. When a new
window appears, select the output stream/channel where the stream will be bypassed or
multiplexed.
To use
Multiplexing mode on service level
click on pencil icon
on the right side in
the line with the proper service. Then select the output stream (channel) where the
service will be multiplexed.
Do not forget to click the Apply button
on the right side to make the change take
effect.
To clear the whole routing table click
button.
There is a channel scan button
on the top.
Normally the input service list of each channel will be loaded in this page automatically,
but when you change the input source, you should refresh the changed channel
manually by selecting the channel and clicking
Channel Scan
button.
3.2.4
IP Output
This menu allows you to configure and access the IP output:
•
Status
•
Basic Settings
•
Service Configuration
Status
tab displays the table of Channels, IP Address, IP port, Effective Bitrate, Total
Bitrate,Bitrate Status (Normal/Overload), TS Analysis and Service List for each IP output
stream. OmniHub 16 IP output has a total of 120 channels which means it can output
120 multicast IP addresses. Once a channel is enabled, the IP address and IP port
configured on the channel will appear in the table. If there are services output in the
channel, the status will display the effective and total bitrate. Total bitrate is the set
