SEMC TF20, Руководство пользователя, Страница: 22 / 30

Last updated 10/29/2020
21
6. Warm up the holder (20°C)
a. Holder should be warmed up with tip pumped down (open V1 and V2).
b. Plug in holder to the temp controller. You should see a value in the DISPLAY window (-
150°C or so). If not, turn POWER OFF and then back ON. While holding down the SET
button (under DISPLAY), hold down the RAISE button (under ADJUST) until the value
under DISPLAY reads +20°. Release the SET and RAISE button when done.
c. Click the AUTO button (under HEATER) to switch out of MAN mode. You should see
bars several red bars under the HEATER window which indicates that the holder is actively
being heated. This step takes ~30 min.
7. Bake out the holder (50°C)
a. After warm up, the holder should be baked out with
dewar/jacket pumped down (close V1, open V2, V3 and
V4). You will need to attach the silver/black/red adapter to
the end of the holder to open V4.
b.
Connect the holder to the temperature controller cord.
See image →
c. You should see a value in the DISPLAY window (+20°C or
so). If not, turn POWER OFF and then back ON. While
holding down the SET button (under DISPLAY), hold
down the RAISE button (under ADJUST) until the value
under DISPLAY reads +50°. Release the SET and RAISE
button when done.
d. Click the AUTO button (under HEATER) to switch out of
MAN mode. You should see bars several red bars under the HEATER window which
indicates that the holder is actively being heated. This step goes overnight.
8.
You’re now done!