SEM 0303, Руководство по эксплуатации, Страница: 17 / 27

16
POP-0044 – Rev. 0
Maintenance
Cleaning
Always de-energize the unit using proper LOTO procedures before cleaning, lubricating, maintaining, removing any guards
and after shredding operation is complete.
SEM recommends wearing cut resistant gloves while performing any maintenance on this unit.
Daily cleaning (after each eight hours of operation)
•
Remove debris and any magnets that have built up on cutters and combers (use a screwdriver or needle-nose pliers).
•
Visually inspect cutters for damage and clear air inlet.
•
Remove side guards and visually inspect drive components for leaks or damage.
•
Replace all guards.
•
Empty waste collection bin.
Weekly cleaning (after each 40 hours of operation)
•
Repeat all daily cleaning steps.
•
Remove side guards and end guards.
•
Remove debris buildup from base.
•
Wipe entire machine clean being careful to observe any evidence of oil leaks. Should leakage be observed, bring to
the attention of maintenance personnel or SEM customer service.
•
Check for loose hardware on the reducer collars, the crusher paddles, etc.
•
Remove all tools, rags, solvents from machine.
•
Replace all guards.
Remove Shredded Material
Under Top Cover Below the Shredder Chamber