15
POP-0044 – Rev. 0
Start Up
PPE:
SEM recommends wearing safety glasses, gloves, and a mask while operating this device.
Turn key switch on and press the forward pushbutton.
For Units with E-Stop:
Insert key into e-stop, actuate the e-stop, and remove the key.
For Combo Units with Chute Block:
Place the chute block over whichever chute is not being used.
For Normal Stop Situations:
Wait 30 seconds for cutting chamber to empty itself before pressing stop button.
In case of
emergency
, simply use the stop button or emergency stop.
Begin feeding material to be shredded into the appropriate feed chute. Reference “capability” section to determine
appropriate media for each chute. Contact SEM customer service for media not listed in the “capability” section.
New Operators:
New operators should be given a minimum two to three hour training period, beginning with a slow feed
rate. The operator will soon be able to judge how quickly they can feed the shredder.
Bin Full:
The bin full indicator will light up when there are approximately 20 lbs. of material in the bin. It is recommended
to empty this out before and after each shift as well. This will be lower for combo units.
For Combo Units: Never use both feed chutes at the same time.
Clearing a Jam
In the event of a jam, ensure that all personnel are clear of both the input chute and the cutter head.
Hold the reverse pushbutton for three to five seconds. This will cause the cutters to run backwards for as long as the reverse
button remains pressed.
Release the reverse button and the machine will come to a stop. After the machine has completely stopped, press the forward
button and try to shred material.
NEVER
hold the forward button in to clear a jam. Damage to the machine may occur.
If machine jams again, reverse shredder again,
de-energize the unit using proper LOTO procedures,
and manually remove
the jammed material. Restart machine in the forward direction to resume operation.
To access the cutting chamber, remove the two screws at the front of the unit on the feed chute cover and lift it up to gain
access. Will require a 5/32 allen wrench.
Shut-Down Procedure
•
Allow cutting chamber to clear all material before shutting down.
•
Press the stop pushbutton.
•
If equipped with an e-stop or key-switch, engage the e-stop or turn the key-switch to the “off” position
•
Turn off the disconnect switch and/or unplug the power cord from the receptacle
•
Open feed chute cover and inspect cutters for damage
•
Open the front door and empty the bin/bins (recommended)
•
Clean any remaining debris from the machine and from the immediate area
o
SEM recommends heavy, cut resistant gloves
Содержание 0303
Страница 14: ...13 POP 0044 Rev 0...