SEM 0303, Руководство по эксплуатации, Страница: 11 / 27

10
POP-0044 – Rev. 0
Modular Output Conveyor (optional)
•
If the optional modular conveyor was purchased, unpack and inspect it for any damage. This item must be ordered at
time of purchase and cannot be added retroactively.
•
After shredder is in position, remove the four bolts that hold the access panel on the back of the shredder.
•
On the front of the shredder, open the access door beneath the cutting chamber and remove the two bolts that are
partially threaded in holes in the side plates. See item 13 below.
•
Move the modular conveyor to the back of the shredder and slide it into the access panel opening. Plug it into the
provided receptacle.
•
Go to the front of the shredder and replace the two bolts through the channel that is on the conveyor to secure the
conveyor to the shredder.
•
Electrical schematic including conveyor outlet available upon request – contact SEM customer service.
ITEM QTY DESCRIPTION ITE
M QT
Y DESCRIPTION
1 1 CONVEYOR SIDE FRAME
OPP 18 1 BEARING MOUNT
ANGLE
2 1 CONVEYOR SIDE FRAME 19 1 BEARING MOUNT
ANGLE
3 2 CONVEYOR LEG 20 1 DRIVE SHAFT GUARD
4 1 CROSSMEMBER 21 1 END GUARD UHMW
COVER
5 1 CROSSMEMBER OPP 22 2 CASTER PAD
6 1 CONVEYOR BED 23 1 END GUARD
7 1 BOTTOM GUARD 24 2 PIVOT BRACKET
8 1 FOOT CROSSMEMBER 25 2 TAKE UP ANGLE
9 2 FOOT CROSSMEMBER
MOUNT 26 2 LEG MOUNT BRACKET
10 2 SIDE SLIDE HOLDER
BRACKET 27 1 DRIVE SHAFT
11 2 ANGLED SIDE SLIDE 28 1 DRIVE PULLEY
12 1 VERTICAL END GUARD 29 1 TAIL PULLEY
13 1 CONVEYOR MOUNT
BRACKET 30 1 TAIL SHAFT
14 1 FOOT OPPOSITE 31 2 PILLOWBLOCK
BEARINGS
15 1 FOOT 32 1 GEAR MOTOR
16 1 BELT SIDE GUIDE 33 2 CASTERS
17 1 BELT SIDE GUIDE OPP 34 2 TAKE UP WELDMENT