SEM 0303, Руководство по эксплуатации, Страница: 10 / 27

9
POP-0044 – Rev. 0
Uncrating and Installation
Your new SEM shredder has been secured to a pallet for shipping. Please inspect equipment immediately for shipping
damage.
•
Important Note: Prior to and after unpacking, check for any damage to the packaging or unit on the Bill of Lading and
contact customer service and the shipping party by phone immediately.
•
Retain packaging for 90 days.
•
Using a lift truck with a minimum capacity of 2,500 lbs. (crated device weighs up to 1,750 lbs.), remove the machine
from the carrier and transport to operation site. Remove pallet and discard responsibly.
•
SEM shredders are equipped with casters for ease of handling.
•
Inspect the machine for any damages prior to installation and operation. Check the oil level and check for any oil leaks.
•
After inspection make certain that all guards and safety devices are installed properly.
•
If an optional discharge conveyor was ordered with your machine, it MUST be installed prior to shredding.
•
Be sure belt is tracking properly after installation.
Uncrating
Tools and PPE needed:
•
Lift truck with minimum lifting capacity of 2,500 lbs.
•
Pry bar and hammer
•
Power drill with Phillips head bit
•
Gloves and safety eyewear
•
Strap cutters
Uncrating:
•
Remove sides of crate – hammer and pry bar
•
Cut straps holding Model 0303 – strap cutters
•
Remove the Model 0303 from the pallet and bring as close to installation point as possible – lift truck
General Installation
•
This unit may be installed in an office or warehouse setting within six feet of an appropriate electrical receptacle.
•
Keep the left side of the unit four inches from any walls or obstructions for proper ventilation.
•
Note: These units are top heavy - use care when moving them and stay clear if they begin to tip.
•
Note: It is recommended to move the unit as close to the installation unit as possible using a fork lift, particularly if it
requires traversing uneven surfaces.
•
Transport: This device is equipped with casters for ease of handling after the device is lifted off the pallet. Ensure
casters are unlocked and push only on flat surfaces. To prevent personal injury or damage to equipment, DO NOT push
the device on inclined or declined surfaces as control of the device may be lost.
•
Storage: If the device requires storage, it may be stored in its shipping crate or unpackaged. If unpackaged, ensure that
the wheel caster locks are engaged to prevent unwanted movement of device.