ECO
installation instructions
Yes
Heating element.
O-Ring.
Plastic ring
Ground Connector (Class I only).
Connectors (phase / neutral)
for the heating element
Fixing screw.
Allen key.
Display.
Button [+] .
Mode Button
ON/Stand-by Button.
Button [-] .
Ambient temperature sensor (Rear)
Cable
NO
For use by installer only
2 Faston connectors 6,3x0,8 mm.
Insulating
Fastening
area
Thread
Synthesis thermostat with electronic control is compatible with
the type of heating element shown in the figure (below).
Example of heating element in class II.
IMPORTANT
:
Pay attention to the maximal length of the
19mm connector (see picture above).
Longer connectors could damage the device.
CLEANING
Disconnect the device from the power network before cleaning or servicing.
Use only delicate, non-abrasive detergents.
WARNING:
Disconnect the power supply before proceeding with installation.
The installation has to be performed only by authorized personnel.
WARNING:
Disconnect the power supply before proceeding with installation.
The installation has to be performed only by authorized personnel.
Filettatura
O-ring
0,5
6
7,5
4
3
25
Max
1,25 45°
N°2
23
18
23
0.5
+
Thermostat
fastening area.
Selmo
Electronic
Via Pacinotti, 24 - 35030 Rubano
www.selmo.it
(PD) Italy- Tel 049.8976761, Fax 049.8976085 -
Selmo
Electronic
Via Pacinotti, 24 - 35030 Rubano
www.selmo.it
“
”
Synthesis Plus
cronothermostat for towel rail
EN
Comfort technology division
Selmo
Rev. 01- Sept. 2017
