Selden Furlex Electric, Дополнительное руководство

Страница: 45 / 52

45
Problem Probable Cause Action
Furlex not operating. Electric failure or bad connection. After furling the sail using the emergency linedriver:
1. Troubleshoot the electric system.
2. Look for corroded or loose wires in the connection box.
Furlex stops when
heavily loaded.
Overload.
1. Ease load and check if operation is OK.
2. See operating instructions, the motor controller will
limit the torque by cutting current supply to the motor, if
overloaded.
3. Check the furling system for excessive friction by using
the hand operated emergency winding system.
Excessive friction in
the furling system.
Salt, dirt, and lack of grease.
1. Rinse with freshwater, clean and lubricate. Please see
the manuals for the standard furling systems.
Furlex runs in wrong
direction.
The wires have not been properly
installed.
1. Connect the cables according to the colour codes
stated in the manual.
2. If opposite furling direction is wanted: Choose any two
of the three motor cables and swap their positions on the
connecting box terminal.
Noise when operating
the Furlex.
Worn gears or mechanical
problem inside the transmission.
1. Dismantle covers and inspect the three gears under
the port cover.
2. If condition is OK, reapply grease and assemble.
3. Hand wind with the emergency socket to check if low
speed rotation is without excessive friction or noise.
4. Contact your Seldén representative for service
instructions.
Oil leakage
Defective seals in motor unit,
or broken housing.
1. Dismantle and inspect
2. Contact your Seldén representative for service
instructions.
Grease leakage
Defective seals in worm gear
transmission, or broken housing.
1. Dismantle and inspect
2. Contact your Seldén representative for service
instructions.
6 Trouble shooting