2
The non-metallic coating is painted on the surface of the product and the non-metallic label is attached on
the surface of the product, electrostatic charge may cause an explosion hazard. Avoid any actions that cause
the generation of electrostatic charge, such as rubbing with a dry cloth on coating surface of the product.
Don’t cover the product with an inflammable material such as cloth or paper nor put anything in the product.
Such a material or thing might cause an explosion or fire.
For outdoor use, waterproof the screw connections and the entries of the terminal box to prevent rainwater
infiltration. For the stanchion type, waterproof the screw connections of the stand pole to prevent rainwater
infiltration. Inadequate waterproofing might cause a fire or electric shock.
Don’t open or loosen any part unless necessary. Confirm that the screws, bolts and the like are fastened
tightly. A loose part might cause an explosion, fall, fire or electric shock.
Prior to maintenance or inspection, be sure to turn off the power and wait at least ten minutes before opening
the enclosure. An explosion, fire or electric shock might result.
If you continue to use the product in an abnormal condition (smoke, odor, etc.), an explosion, fire or electric
shock might result. If you detect an abnormality, immediately turn off the power switch. Confirm that the
abnormal condition has been eliminated and have it repaired by a specialist.
The components once removed for cleaning or maintenance should be replaced properly according to the
instruction manual. An incorrectly placed component might cause an explosion or fall, resulting in an injury or
property damage.
WARNING
When leading the power cable into the product, be sure to follow the technical standards for electrical
equipment and the guide for the explosion protection of factory electrical equipment. Inadequate cable
connection or poor waterproofing might cause an explosion, fire or electric shock.
In grounding work, follow the technical standards for electrical equipment and the guide for the explosion
protection of factory electrical equipment. Inadequate grounding might cause an explosion, fire or electric
shock.
Don’t convert the product.
Conversion might cause fall of the product, an explosion, fire or electric shock.
CAUTION
To ensure brightness and safety, carry out cleaning and inspection periodically. （If the product is using in
explosive dust area, regular dust cleaning must be done but don't clean the surface by air gun. ）
If you find a problem, stop using he product and have it repaired by a specialist.
Never touch the lamp and its surroundings while it is on or just after it is turned off.
The lamp and its surroundings are very hot. An accidental touch might burn yourself.
Don’t use the product at a voltage other than the voltage indicated on the nameplate. The voltage variation
should be within ±6% of the rating. Otherwise a damage, fire or electric shock might result.
Don’t use the product at a frequency other than the local power supply frequency (50 or 60 Hz).
A wrong frequency might cause a fire.
The product should be installed by a qualified person.
Installation by an unqualified person is legally prohibited.
Because this product is painted non-metallic coating , please refer to the note below.
・Avoid friction ・No dry cleaning ・Do not mount in areas with flowing, non-conductive products
Содержание WLZAA14021
Страница 7: ...7 ...
