28
Step １
Step 2 Step 3
Step 4
Step 5 Step 6
Step 7
Step 8 Step 9
Step 10 Step 11 Step 12
Step 13 Step 14
Place the PE film on the
printhead
Cut the PE film into 30cm x30cm
Prevent the film to get wrinkle。
Close the cap.Ensure the
washer is in the cap.
Wrap the printhead from the edge of the film.
Pull the film tightly to seal the printhead as
much as possible
Seal the printhead on both
sides.
Gently remove the air between the
film and the surface of nozzles.
Install the printehad stand.
Wrap the film on the top of the
printhead.
Caution:
（1）Remove the remaining solvent in the printhead totally.
（2）Tighten the cap properly:
If the washer is in the proper position, the cap can be
tighten easily.
Do not force to tighten the cap when the position of the
washer is not proper.
（3）Wrap the printhead carefully.
Wrap the film to the other side,
and seal the head.
。
Make sure the stand is
properly installed
Put the printhead into the
orginal plastic box.
Put the nozzle check together
Put the printhead and the
nozzle check into the
anti-static bag.
Put the plastic box into the
paper box
Ink inlet
PE film
Make sure there
are no bubbles
and wrinkles.
