17
Note: K is the reference. At the “0” point, other color should overlapped on K. If not, look for the
rectangle which is overlapped, and input the corresponding value into the “Head Adjustment”.
The following example use C (to right) to demonstrate:
As the picture shown above, the rectangle of C and K are overlapped well at “-1”, at “0” C and K are
separate, so it need to correct at the software. Following is operating step:
Enter “Setting->Option”, shown as the below picture:
Choose “Head Adjustment”
Please print the adjusting picture again after inputting and saving the parameters. Check if the color lines
are overlapped on K.
Repeat the above steps until the rectangle at “0” overlapped each other.
0
-1
-2
-3
3
2
1
Y Direction Offset (K is standard),
check the value with adjusting
picture, accumulate that value
with original value.
No need to adjust if Physical
alignment is well.
“X Direction Offset”, check the
value with adjusting picture,
accumulate that value with
original value.
The value of K-C(to right)should
be
：
（
-1
）
+0= -1
To Right
To Left
To Right
To Left
Based parameter
0
-1
-2
-3
3
2
1
