Segway Personal Transporter i2, Руководство по замене запчастей

Страница: 31 / 126

Segway® Personal Transporter i2, x2, x2 Turf Parts Replacement Guide 3 ‐ 1
3. Battery Packs
This chapter describes removal and installation procedures for
the Li ‐ ion batteries used on a Gen 2 Segway PT. For
information on using the batteries, including charging and
maintaining them, safety rules, specifications, and general
care, refer to Segway PT i2, x2 Reference Manual.
The following warnings apply to the instructions in this
Section 3 regarding Battery Packs:
Failure to do so
could result in
serious injury or
death.
Failure to follow
these instructions
could lead to
electrical shock,
serious injury, death,
or damage to
property.
Failure to follow
these instructions
could lead to
electrical shock,
serious injury, death,
or damage to
property.
FASTENERS
•
Use only Segway-approved fasteners.
•
Do not tighten or reuse any fastener except the screws used to
attach the battery packs, wheel nuts, and LeanSteer frame.
Instead, when any other fastener is loose or removed, replace
the fastener with a new Segway-approved fastener. See
Appendix C, ”Fasteners” for more information.
•
Do not attempt to repair any stripped or damaged screw hole.
Instead, replace the part. If replacement part is not available,
do not reassemble.
•
Insert fasteners slowly and carefully. Do not cross-thread or
over-tighten fasteners. Tighten only to the prescribed torque.
•
Failure to adhere to these warnings could lead to serious injury
or death or damage to property.
Read
all
instructions.
Power off
the Segway PT.
Unplug
the
Segway PT.
Applies to Models
i2, x2, x2 Turf
Qualifications
Customer Replaceable
Customer Replaceable Kit
Battery Kit (20878 ‐ 00001)
(1) Li ‐ ion Battery
(4) Fasteners, M4 x 0.7 x 30
Required Tools
•
Torque wrench, 3mm drive
•
Hex wrench, 3mm