Sega OUTRUN 2 SPECIAL TOURS SDX, Руководство по обслуживанию

Страница: 79 / 83

TOWER
AND BILLBOARD TEST MODE
73
4
4-3 SETTINGS FOR WHEN 1 OR MORE UNITS HAVE BROKEN DOWN
This section explains the settings to use when a cabinet cannot be used because of some sort of malfunction.
The following procedure explains how to change the settings from 4-unit network play to 3-unit network play, for
situations where 1 unit has broken down.
1
Turn off all power (control tower power). (See 1-4.)
2
Turn off the power switch of the cabinet with the malfunction. The switch is on the left side of the DLP
base.
3
Change the DIP SW settings on the tower control board inside the control tower.
The DIP SWs numbered 5, 6, 7, and 8 correspond to 1P, 2P, 3P, and 4P, respectively.
Flip the DIP SW of the malfunctioning cabinet to ON. Ordinarily, it is set to OFF.
4
Turn on the control tower’s power. Restore power to cabinets without malfunctions.
Because the units are configured for 4-unit network play, but 1 unit does not have power, the network check
message will continue to display on the screens after initialization operation.
5
Put the cabinets that have power into Test Mode.
6
Adjust settings for 3-unit network play at the Game Setting Screen.
Set TOTAL MACHINE to 3.
Set the LINK ID of the cabinets, from the left, to 1, 2, and 3.
7
Exit Test Mode. After initialization operation and network check, the 3 units will display the Customer
Welcome Screen, indicating that setup is complete.