Sega OUTRUN 2 SPECIAL TOURS SDX, Руководство по обслуживанию

Страница: 57 / 83

EXPLANA
TION OF TEST
AND DA
TA
DISPLA
Y
ACTUATOR CONTROL BOARD TEST
L CW LIMIT SWITCH OFF
L CCW LIMIT SWITCH OFF
R CW LIMIT SWITCH OFF
R CCW LIMIT SWITCH OFF
L ACTUATOR ***mm
R ACTUATOR ***mm
-> INITIALIZE
L ACT CW MOVE
L ACT CCW MOVE
R ACT CW MOVE
R ACT CCW MOVE
LR ACT CW MOVE
LR ACT CCW MOVE
L ACT CW R ACT CCW MOVE
L ACT CCW R ACT CW MOVE
ACTUATOR MOVE SPEED LOW (MID /HIGH)
EXIT
SELECT WITH SERVICE AND PRESS TEST
FIG. 3-3db Actuator Control Board Test Screen
(2) Actuator Test Operations
Once starting a procedure, the actuator will operate until it detects the limit switch. If the limit switch is not detected,
the actuator will emit a very loud sound. Press the MOTION STOP button to stop the ride. Also, there may be cases
where the ride is stopped due to an overload error.
When the limit switch cannot be detected, the limit switch requires adjustment. Request the work by done by the
office listed in this manual or by the point of purchase.
Before the below operations are conducted, the seats return to their level position.
INITIALIZE :
The rear of the ride will move up and down, initializing the actuator. (Time: about 20 seconds)
L ACT CW MOVE :
The left side of the ride will go down, and the actuator’s limit switch will be detected. When the limit switch is
detected, the L CW LIMIT SWITCH display will show “ON,” and the actuator will stop at that position.
L ACT CCW MOVE :
The left side of the ride will go up, and the actuator’s limit switch will be detected. When the limit switch is detected,
the L CCW LIMIT SWITCH display will show “ON,” and the actuator will stop at that position.
R ACT CW MOVE :
The right side of the ride will go down, and the actuator’s limit switch will be detected. When the limit switch is
detected, the R CW LIMIT SWITCH display will show “ON,” and the actuator will stop at that position.
R ACT CCW MOVE :
The right side of the ride will go up, and the actuator’s limit switch will be detected. When the limit switch is
detected, the R CCW LIMIT SWITCH display will show “ON,” and the actuator will stop at that position.
LR ACT CW MOVE :
The left and right sides of the ride will go down, and the actuators’ limit switches will be detected. When the limit
switches are detected, the L CW LIMIT SWITCH and R CW LIMIT SWITCH displays will show “ON,” and the
actuators will stop at that positon.