Sega OUTRUN 2 SPECIAL TOURS SDX, Руководство по обслуживанию

Страница: 21 / 83

PRECAUTIONS REGARDING PRODUCT OPERA
TION
If the power is turned off when the actuator that moves the ride is in an elongated condition, noise will be emitted
when the ride contracts.
Although there is no concern about wear or overloading, this occurrence is likely to cause apprehension. The
following is an explanation of how to turn the power off quietly by adhering to a certain set of steps.
Note, however, that this power off procedure cannot be conducted while a game is in progress.
1
Turn off the main switch on the service panel of the control tower. (See Fig. 1-2b.)
2
When you wish to turn off the power switches of the four cabinets, press the START button on the service
panel for an extended period. Press the START button continuously for at least 3 seconds until the rides start
to move.
3
Each ride will move to its bottommost point and then stop.
4
Turn off the power switch on the control tower. This switch is behind the lid on the left side seen facing the
control tower. (See owner’s manual FIG. 4c.)
If you turn off the power without carrying out the above procedure, the ride will descend a little at a time while
emitting a noise. This is the noise of the elongated actuator contracting.
Although the actuator will not wear due to this operation, you should carry out the above procedure before turning
off the power.
5
Before carrying out maintenance on a particular cabinet and cockpit, turn off the power switch on the side
of the DLP base of the target cabinet. (See owner’s manual FIG. 4b.)
To turn off only the target cabinet, press the ENTRY button for the target cabinet on the service panel for an extended
period.
Press the button continuously for at least 3 seconds until the ride starts to move.
Only the ride of the target cabinet will move to its bottommost point and then stop.
- SWITCHING OFF THE POWER