SEF 551.10, Руководство по эксплуатации

Страница: 65 / 238

Page 5.7
5.0 Transport and setting up
Transport 551.19 \ 12.2015 \
System setup
System 551.10 / 551.15 setup and alignment
Working table
The soldering systems of the series 551 are delivered largely pre-
assembled.
On the installation site, you must still perform a few connection work
for soldering ovens 551.10 / .15:
y
Place the supplied base cabinet or a comparable stable
working desk at the place of production and align it with
the help of the machine feet. Make sure that the working
desk stands firm as does not jiggle.
y
Lift the soldering system with a minimum of 4 persons
on the working desk/base cabinet.
y
Set up soldering system 551.10 / .15 on base cabinet or
working table and align it horizontally with the help of the
machine feet (see below).
The soldering oven 551.10 / 551.15 is designed as a desk model.
The working table must be stable and capable of the soldering sys-
tems weight.

We recommend to use the special designed base cabinet
551.10.1 with a lot of stowage for the safe set up of the
soldering system.
NOTICE
Risk of breakage
The soldering system 551.10 / .15 has a weight of 175 kg .
y
The working table must be capable of the soldering sys-
tems weight and the dimensions.
y
Move the soldering system 551.10 / .15 on the transport
pallet to the final place of production with an appropriate
means of transport, such as hand lift or fork truck.
y
Remove the four securing screws M10x70, which are
screwed from underneath through the transport pallet.
y
Place the transport pallet with the soldering oven on the
floor.
y
Now screw the feet instead of the transport locks from the
bottom to the soldering oven.
(You can do this by lifting the soldering ofen at one side and
place a squared timber (e. g.) under the bottom of the unit in
order to achieve the thread.)