Security Chimneys International LE LAVAL, Инструкция по установке и эксплуатации, Страница: 12 / 39

10
3.3.4 Door Frame Finish Care
Use a glass cleaner and a soft cloth to polish the casing. Do not use abrasives such as steel wool,
steel pads or an abrasive polish for they may scratch the frame‟s finish.
3.3.5 Ashes
Remove ashes only when the fire is out and the ashes are cold (24 to 48 hours after the fire is
out). Always use a metallic container to dispose of the ashes.
3.3.6 Refractory Brick Replacement
The intense heat of the fire will normally cause
hairline cracks in the refractory brick. These
cracks can be minimized by proper curing as
described in section 3.2.2. They will not
normally diminish the effectiveness of the
refractory brick. If large cracks develop, then the
refractory should be replaced. To replace the
refractory bricks, follow these steps:
1. Remove the front refractory bricks
2. Remove the andirons
3. Remove the side refractory supports
4. Remove the side refractory bricks
5. Remove the back refractory brick
6. Remove the bottom refractory brick
To install the new refractory bricks, follow the above steps in reverse.
3.3.7 Door Installation
The doors Of the Le Laval fireplace are factory installed. To remove
the doors, remove the finishing trim then simply pull them up from
the hinges. The door adjustment has been set at the factory. If the fit
is still not perfect, you can adjust the door using the hinge screws.
(See fig 6-1)
Figure 5
Figure 2