SECOMX-945/N270
User Manual
- Rev. First Edition: 0.1 - Last Edition: 2.1 - Author: S.B. - Reviewed by G.M.
Copyright © 2011 SECO s.r.l.
SECOMX-945/N270
pag. 33
4.5.4 COMB IrDA signal pin
Using this option it is possible to select which signals use COMB in IrDA mode, if IRRX/IRTX or
RX2/TX2
4.5.5 LPT mode
This option allows the selection of working mode of internal LPT parallel port. It can be set to work
in a
standard
mode,
PS/2
mode,
EPP
mode (in this case, it can be selected if to work in 1.7 or in
1.9 mode),
ECP
mode or
EPP + ECP
mode or
Disabled
.
4.5.6 LPT IRQ
When internal LPT is enabled, this option allows to choose which IRQ line is assigned to the
internal LPT1 (possibilities are IRQ 3, 4, 5, 6, 7, 10, 11, 12 or None)
4.5.7 FDC Controller
This option allows enabling or disabling the internal Floppy Disk Controller of SuperI/O (if your
SECOME-945/N270 module supports this double possibility).
4.5.8 Parallel connected to
This option determines which signals are available on X3 connector:
FDC
will set Floppy Support
Mode,
LPT
will set Parallel Port Mode. Again, FDC interface is available only in case your
SECOME-945/N270 board does support this feature.
4.5.9 Pointing device (Mouse)
This option enables or disables the mouse port.
