3
ENFORCER Vandal Resistant Flush-Mount Access Control Keypad
SECO-LARM U.S.A., Inc.
Quick Programming Guide:
This page is for installers looking to do a basic installation and programming of the keypad.
For more in-depth installation and programming instructions, see the Table of Contents on page 4.
Programming Tips:
•
The master, super user, visitor, duress, and user codes cannot be the same.
•
A flashing amber LED indicates the keypad is in standby mode. A solid amber LED indicates
the keypad is in programming mode.
•
If the keypad is set for
Auto Code Entry Mode, all codes
will need to be
the same number of
digits
as the
master code
(see page 24).
Programming Instructions:
Follow the instructions below if the following covers your needs:
•
A new master code.
•
A single 4-digit user code for all users.
•
One output to unlock a door.
•
A 3-second delay time in opening the door after the output is activated.
1. Turn off the beeping before the 1-minute power-up period ends:
12 #
2.
Enter Programming Mode
:
0000 **
NOTE:
0000
is the default master code.
3. Change the master code:
01 xxxx #
NOTE:
xxxx
is the new master code.
4. Set the user code to operate output #1 (unlock the door):
10 2 000 xxxx #
NOTE
:
000
chooses user ID #000 of 1,000 possible users (000~999).
XXXX
is the new user code for user ID #000.
5. Set the output #1 delay time (skip this step if the default value of 5 seconds
is acceptable):
51 3 #
NOTE
:
3
sets the output #1 delay time for 3 seconds.
6.
Exit Programming Mode:
**
