24
ENFORCER Vandal Resistant Flush-Mount Access Control Keypad
SECO-LARM U.S.A., Inc.
Programming the Keypad Sounds:
Some of the keypad sounds can be programmed off:
•
Keypad audible mode – All the keypad’s status beeps are enabled.
•
Keypad silent mode – The successful key entry beep (1 beep) and the unsuccessful user code
entry beeps (5 beeps) are disabled. However, the warning and power-up delay beeps remain
active. This provides for a quieter work environment.
To Program:
•
To enable keypad audible mode (default):
71 1 #
•
To enable keypad silent mode:
71 0 #
NOTE
: This programming function only impacts the keypad sounds. It does not impact the output
relay activation sounds (see “Programming the Output Relay Activation Sounds”
on page 25).
Programming the User Code Entry Mode:
The keypad can be programmed for auto or manual user code entry modes:
•
Auto entry mode – Pressing the
#
key is not required after typing in a user code. In auto entry
mode, all user codes must have the same number of digits as the master code.
•
Manual entry mode – The
#
key must be pressed after the user code to indicate the code has
been entered completely. In this case, the user codes can have a different number of digits, from
4 to 8 digits.
To Program:
•
For auto entry mode:
70 1 #
•
For manual entry mode (default):
70 2 #
NOTE
: If the keypad was previously programmed for manual code entry mode and then is
reprogrammed for auto entry mode, any codes whose length exceeds the number of
digits of the master code will no longer operate the keypad. However, if the keypad is
reprogrammed for manual entry mode, the longer codes will again operate the keypad.
