Seakeeper 5500 GYRO, Руководство по установке

Страница: 46 / 66

WORK INSTRUCTIONS Page 2 of 3
Product: M7A, M8, M21, M21A, M26, &
M5500
Document #: 020
Process: Installation Instructions, 24VDCPower Connector for Gyro Control Box Rev: 5
Steps 3 ‐ 8
3. Trim cable jacket as shown.
4. Strip insulation on wires as shown.
5. Install ferrules on wire ends using
Weidmüller crimp tool PZ 4 (or equiv).
Ferrules are not required if bare conductor
nearly fills the screw terminal.
Ferrule part numbers: McMaster ‐
Carr7950K69, Weidmüller 9019190000.
6. Insert wire ferrules into connector screw
clamps according to schematic diagram
and tighten. Apply dielectric compound
on terminal surfaces to prevent
corrosion.
7. Position backshell over screw clamps and
thread into connector and tighten.
8. Slide spacer and clamp into place behind
backshell. Then thread compression nut
into backshell and tighten.
Contact assignments shown from rear
(screwterminal end).
2 (+24VDC)
1
(not used)
(24VRtn) 3