Seagate STT20000N, Руководство по эксплуатации продукта

Страница: 29 / 70

Installation Chapter 3
STT20000N Product Manual Page 21
Installing the drive
The following steps guide you through installing the internal Travan drive.
Caution: Turn off your computer before you begin the installation. Failure to do
so might result in damage to your equipment or electrical shock to you.
Note: Because computer models vary between manufacturers, refer to your
computer manual for specific installation instructions.
1. Write down the serial number and model number shown on the drive and put
this information in a safe place. You need this information if you ever call for
service.
2. Refer to the manual that you received with your computer for instructions about
removing the computer cover and the face plate from the drive bay in which you
plan to install the drive.
Note: If devices are installed in any drive bays adjacent to the one you are using
for the internal drive, partially removing those devices might give you more
working space.
3. Check that jumper settings and termination are correct for your installation.
(Refer to the previous text under
Configuring the Drive.)
4. Attach any special mounting hardware to the drive that your system might
require. Refer to the manual that you received with your computer for
requirements.
5. Locate the mounting screw holes in the drive brackets. Each side contains two
sets of holes. Use the set that aligns the drive properly within the drive bay.
6. Slide the tape drive into the computer so that the drive bezel and the computer
face plate are flush. Then, align the mounting holes.
7. Secure the drive using the mounting screws. The threaded mounting holes are
designed for M3.0 metric screws. The maximum length for the M3.0 metric
screws is 4 mm. Use of longer length screws may damage the drive. See
following section for mounting dimensions.
8. Connect an available power cable to the power connector on the drive. The
recommended power mating connector requires an AMP 1-48024-0 housing
with AMP 60617-1 pins or equivalent.
Note: Turn off all power before inserting connectors.
9. Connect the mating SCSI connector (the single-ended connector described
previously in
Cabling and Connectors) with the SCSI connector on the rear of
the unit. When you make the connection, be sure pin 1 of the connector aligns
with pin 1 on the SCSI connector.