Sea Tel DAC-2202, Инструкция по установке и эксплуатации

Страница: 77 / 115

DAC-2202 Antenna Control Unit Diagnostic M&C Software Installation & Use
7-27
In the CommPort Properties Dialog box, select
the TCP/IP radio button.
Enter in the ACU’s IP address information
Enter in the ACU’s Port Number
If desired, turn Echo On. (Not required)
Click On “OK” to submit and save these
communication settings.
Verify Port Status reports valid
communications. Port Status
LED Color
Communications
State
Clear Waiting State
Red No PC to System
Communications
Yellow No Response to
Sent Query
Green Valid
Communications
Blue Time Out Error
Note: If you experience a communications fault, as evidenced by a RED communications LED, ensure your
computers network settings are of the network subnet as that of your ACU. If all settings and cable
connections have been verified and you still are not able to establish a connection, Authentication may
have been turned on and will not allow a TCP/IP based DacRemP remote connection. Refer to TCP/IP
Security text for instructions on how to turn security off.
7.17.2. Serial Based
If not already, apply power to the ACU
Click on the “DacRemP” icon to open the
DacRemP diagnostic program.
Under the Comm Port Menu, select Properties.
In the CommPort Properties Dialog box, select
the Serial radio button.
Using the drop down menu, select the Com
port number. Using the drop down menu,
select the Baud rate of the ACU you are
connected to. (All DAC2x02 ACU’s are shipped
out at 9600)
Leave Connection Parameters to 8, None, 1,
and None for Flow Control.
If desired, turn Echo On. (Not required)
Click On “OK” to submit and save these
communication settings.