Sea Tel DAC-2202, Инструкция по установке и эксплуатации

Страница: 17 / 115

DAC-2202 Antenna Control Unit Operation
2-9
NID 0000 AGC 1234
Press
DOWN
or
ENTER
to access the
NID sub-menu
. This setting, a
four digit
HEX
value with a valid range of 0000-FFFF, is based on the desired received
transponders’ Network ID (NID). If this parameter is provided in decimal format, it
will have to be converted to hexadecimal for entry.
Set the NID value to 0000 if;

The signal you intend to track does not contain a valid NID.

You do not want to use satellite identification function.

You are using the external AGC input source from the satellite
modem (
most commonly used in the 09 Series antennas ) which
has been provided to you in your system configuration.

You are experiencing a hardware/software issue which is preventing the
ACU from decoding the NID and you want to temporarily disable this
function.
To manually update, press the LEFT or RIGHT arrow key to bring the cursor up
under a character. Continue to move the cursor until the desired character to be
edited is underscored (selected). Use the
UP or DOWN arrow keys to increment or
decrement the selected character.
Press
ENTER
to set the desired NID OR Press
NEXT
to abort and return to the main
Satellite display.
2.6.3. Antenna Information Menus.
Display Meaning
AZ 123.4 EL 056.7
REL 234.5 AGC 1234
Press the NEXT key until the Antenna main menu is displayed. This is the display
of the current Antenna information.
While in the antenna main menu pressing the
UP
,
DOWN
,
LEFT
or
RIGHT
arrows
moves the antenna in those respective directions. Quick pres & release the desired
arrow key will
step the antenna in small individual increments. Press & Hold the
desired arrow key to slew the antenna in rapid steps.
AZ 123.4
# AGC 1234
Press
ENTER
to access the
Azimuth sub-menu.
This allows you to target the
antenna to desired Azimuth position. The current IF signal level (AGC) is displayed
to assist you in manually peaking AZ for best signal level. Range of input is 000.0-
359.9.
To target a new azimuth position, press the
LEFT
or
RIGHT
arrow key to bring the
cursor up under the character to the left, or right, of the decimal point respectively.
Continue to move the cursor until the desired character is selected. Use the
UP or
DOWN
arrow keys to increment or decrement the selected character.
Press ENTER to target the antenna to the new Azimuth position OR Press NEXT to
abort and return to the main Antenna display.
The number ( 2, 4, 6 or 8 ) you see periodically flashing in the lower left of the
display are normal DishScan tracking signals.