Sea Ray 270 Select EX, Руководство пользователя

Страница: 69 / 126

6.3
S
ECTION
6 • E
LECTRICAL
S
YSTEM
270 Select EX
Use of higher amperage fuses or breakers is a fire
hazard.
Use fuses and breakers having the same amperage
rating as the original or as specified.
! WARNING
component board (see Fig. 6.4.1). If you need to
replace a fuse,
use only the same amperage as
the original. It is recommended that you carry
spare fuses. See Fig. 6.3.1 and 6.4.1 for the proper
fuse sizes.
If a fuse is replaced with one of lower amperage, it
will not be sufficient to carry the electrical load of
the equipment it is connected to and will cause
nuisance fuse failure.
If a fuse or breaker is replaced with one of higher
amperage, it will not provide adequate protection
against an electrical malfunction and will create a
fire hazard.
Protective terminal covers, such as rubber boots
on electrical connections, must be in place when
engine is operating or when working in the engine
compartment.
Jumper cables are not ignition-protected. DO NOT
USE jumper cables in the engine compartment. The
engine compartment may accumulate dangerous
explosive gasoline fumes/vapors and hydrogen gas
from batteries being charged. A spark produced
when connecting a jumper cable can cause an
explosion.
F
USE
C
ONDITION
(ATO T
YPE
F
USE
)
GOOD FUSE BLOWN FUSE
A
CCESSORY
F
USE
B
LOCK
(L
OCATED
B
EHIND
A
CCESS
P
ANEL IN THE
STBD S
TORAGE
)
(F
IG
. 6.3.1)
FUSE NAME FUSE AMPERAGE 12VDC
1. HORN 5
2. IGNITION 15
3. NAV LIGHTS 10
4. BILGE BLOWER 7.5
5. WINDSHIELD WIPER 5
6. BILGE PUMP 7.5
7. WATER PUMP 10
8. RECEPTACLE 15
9. TRIM TABS 20
10. LIGHTS 10
11. SPOTLIGHT 15
12. HATCH LIFT 10
13. DOCKING LIGHTS 10
14. REFRIGERATOR 10
15. VHF 10
16. CO MONITOR 1
17. CHART 2
18. ACCY BLANK
(
*
REFER TO MANUFACTURER’S RECOMMENDATION FOR FUSE RATING
FOR CHART PLOTTER)
3. F
USES
Fuses are located in two areas on your 270 SLX.
The accessory fuse block is located behind the
access panel above the Main Distribution Panel in
the STBD Storage area. The access panel can be
removed by removing the four (4) screws that hold
it in place. There are also several fuses on the bilge
SCREWS