89
Boat Cleaning/Repair
Wash the body and the trailer with soap
and water solution (only use mild deter-
gent). Rinse thoroughly with fresh wa-
ter. Remove any marine organisms
from the hull.
CAUTION:
Never clean apparent fi-
berglass and plastic parts with
strong detergent, degreasing agent,
paint thinner, acetone, etc.
Stains may be removed from seats and
fiberglass with Knight’s Spray-Nine or the
equivalent.
If repairs are needed to the body or to
the hull contact your authorized Sea-
Doo sport boat dealer. For paint touch
up to mechanical parts use Bombardier
spray paint. For minor gelcoat repairs,
a Gelcote
1
repair kit is available from
Gelcote International (www.gelcote.ca).
Replace damaged labels/decals.
Once boat is on trailer, unscrew the
drain plug, block the wheels and raise
the bow slightly with the trailer jack (if
so equipped) to allow water to drain.
Clean the bilge with hot water and de-
tergent or with bilge cleaner. Rinse
thoroughly. Leave all compartments
open to air dry.
Finalizing Storage Preparation
Apply a non-abrasive wax to body.
The engine storage cover should be
left partially opened during storage
(detach the gas shocks from the cover
to prevent full opening). Remove stor-
age tray. Place it on deck.
Using a flat screwdriver, lift tab as
shown below.
TYPICAL — LIFT TAB
Detach shock end. Detach other side.
Block and leave engine cover lid open
slightly.
This will avoid engine compartment
condensation and possible corrosion.
Reattach shock ends to engine cover
lid before operating boat.
If the boat is to be stored outside, cov-
er it with a vented opaque tarpaulin to
prevent UV (ultraviolet) rays and grime
from affecting the plastic compo-
nents, boat finish, as well as prevent-
ing dust accumulation.
NOTE:
Never leave the boat stored in
direct sunlight. UV radiation will dull
finishes. The boat must never be left
in water for storage. Make sure to turn
off main battery cut-off switch.
For the storage period, block the
wheels and raise the bow slightly with
the trailer jack (if so equipped) so drain-
age can take place. Ensure the drain
plug is unscrewed and unobstructed.
1. Gelcote is a registered trademark of Gelcote Inter-
national
F04LBHY
lmo2005_002a.book Page 89 Tuesday, July 6, 2004 3:44 PM
Содержание Speedster 200
