51
40) Ventilation Ducts
Located beneath the engine compart-
ment lid, the ventilation ducts allow air
flow to ventilate engine compartment
and to supply air to engines. Never ob-
struct the ventilation ducts.
TYPICAL — PORT SIDE SHOWN
41) Bow/Stern Eyelets
Eyelets can be used for mooring, tow-
ing and as a tie-down point during
transportation.
TYPICAL
1. Stern eyelet
42) Jet Pump Nozzles
Jet pump nozzles provide directional
control of boat when engines are run-
ning, turning side to side via input from
the steering wheel. Refer to PROPUL-
SION under PRINCIPLE OF OPERA-
TION.
43) Reverse Gates
When selecting the neutral or reverse
position with the shift lever, the re-
verse gates move up or down, obtain-
ing the desired position.
44) Scupper Valve
Location where water drains out from
the deck. Keep clean to avoid clogging.
TYPICAL
1. Scupper valve
45) Fuel Tank Vent
The fuel tank vent is located in the fuel
tank cap and allows fuel vapors and
pressure to escape from fuel tank.
WARNING
Never use nozzle as a supporting
point to board the boat or to lift it.
F13L1HY
F13L1IY
1
WARNING
Never use gates as a supporting
point to board the boat. Shift lever
should only be used when the en-
gine is idling and boat is complete-
ly stopped.
WARNING
Never use a lit match or open flame
close to vent. Follow the FUELING
PROCEDURE instructions in the
FUEL AND LUBRICATION section.
F13L1IZ
1
lmo2005_002a.book Page 51 Tuesday, July 6, 2004 3:44 PM
Содержание Speedster 200
