SDT International SDT170, Руководство пользователя

Страница: 8 / 141

8
4. Using the SDT 170 S and S+
The chapter allows a quick use of the SDT 170 S and S+. It is nevertheless highly
recommended to read carefully the whole manual before using the equipment.
This chapter can therefore be considered has a quick reference guide.
4.1 R
ECHARGING ON THE EQUIPMENT
Refer to the chapter 3.
4.2 S
WITCHING ON THE EQUIPMENT
1. Remove the sensor protective cap and press the key to switch on.
The build in automated self-test is started and takes about 2 seconds to
finish.
2. The unit is ready to use if no problem or fault is detected during this
build in self-test.
The message
Battery charge too low
flashes on the screen when the
battery pack’s charge is to low. Recharge the battery; see previous chapter.
4.3 T
HE SCREEN AFTER POWER ON
The SDT 170 S+ displays a digital measurement, while the SDT 170 S only
displays a bargraph.
SDT 170 S
The display shows the information as indicated in the following picture.
The measurement screen of the SDT 170 S displays a bargraph.
081
SDT 170 S+
The display shows the following information.