SDT International SDT170, Руководство пользователя

Страница: 20 / 141

20
6. Using the SDT 170 MD
The chapter allows a quick use of the SDT 170 MD. It is nevertheless highly
recommended to read carefully the whole manual before using the equipment.
This chapter can therefore be considered has a quick reference guide.
6.1 R
ECHARGING ON THE EQUIPMENT
Refer to the chapter 3.
6.2 S
WITCHING ON THE EQUIPMENT
1. Remove the sensor protective cap and the key to switch on.
The build in automated self-test is started and takes about two seconds to
finish.
2. The unit is ready to use if no problem or fault is detected during this
build in self-test.
The message
Battery charge too low
flashes on the screen when the
battery pack’s charge is to low. Recharge the battery; see chapter 3.
6.3 T
HE SCREEN AFTER POWER ON
If the SDT170 works with the:

Continuous function, the screen is as shown below (see paragraph 6.6).

Max val function, the screen shown any numeric value (see paragraph 6.6).
The measurement screen.
083