SCOV SV600 Series, Руководство пользователя

Страница: 59 / 198

SV600 Series User Manual 6 Parameters List
53
Group P5: Output Terminals
Function
code
Name Setting range Default Property
P5-00 HDO output mode selection
0: Pulse output (HDOP)
1: Switch signal output (HDOR)
0
☆
P5-01
HDOR output function
selection
0: No output
1: Frequency inverter running
2: Fault output (freely stop fault)
3: Frequency level detection FDT1 output
4: Frequency reached
5: Zero speed running (no output at STOP)
6: Motor overload pre-warning
7: Frequency inverter overload pre-warning
8: Set count value reached
9: Count value reached
10: Length reached
11: PLC cycle complete
12: Accumulative running time arrived
13: Frequency limited
14: Torque limited
15: Run Ready
16: AI1 > AI2
17: Upper limit frequency reached
18: Low limit frequency reached (No output at
stop)
19: Undervoltage status output
20: Communication setting
21: Reserved
22: Reserved
23: Zero Speed Running 2 (Output atstop)
24: Accumulative power-on time arrived
25: Frequency level detection FDT2 output
26: Frequency 1 reached
27: Frequency 2 reached
28: Current 1 reached
29: Current 2 reached
30: Timing reached
31: AI1 input limit reached
32: Underload
33: Reverse running
34: Zero current state
35:IGBT temperature reached
36: Output current limit exceeded
37: Low limit frequency reached (Output at stop)
38: Alarm output (all faults)
39: Motor overheat pre-wawrning
40: Current running time arrived.
41: Fault output (No output when it’s fault with
freely stop or under-voltage)
0
☆
P5-02
Control board relay function
selection
(T/A-T/B-T/C)
2
☆
P5-03 Reserved
P5-04
DO1 output function
selection
1
☆
P5-05 DO2 output selection 4
☆