Scott QuadScan II 7400, Руководство по эксплуатации и техническому обслуживанию, Страница: 64 / 121

59 of 116
Press the ENTER button. Note: You can not use the
ESCAPE button to back out of this submenu. You
must press ENTER.
Press the UP or DOWN button.
*Current Software Version will be displayed.
YES can be selected by pressing the ENTER
button, but for this example the default NO will be
used.
Press the UP or DOWN button.
Press the ENTER button.
Note 1: To program any relay for specific alarms,
the following letters, numbers and symbols are
used: W (Warn), A (Alarm), F (Fail),
1,2,3,4(Channel numbers), & (AND), (OR), (
and ) (used to separate groups of alarms).
Note2: The LCD can display 16 letters, numbers
or symbols out of 32 at one time on the LCD.
Each time the SETUP button is
pressed, the program position moves 1 flashing
position to the right. The flashing position will wrap
around to the first position.
Note3: If a mistake is made during entry of the
selection, press the RESET/Silence button to
delete a character. Corrections can then be made
without using the ESCAPE button. Note: The first
character in the string cannot be deleted.
If you wish to change the W to A or F, press the
UP button to select your requirement. For this
example, use the Factory Default W.
Press the SETUP button
If you wish to change the 1 to another channel
number, press the UP or DOWN button. If you
wish to add additional alarms or AND and OR
functions, press the UP or Down buttons and the
SETUP button to move to the next position to the
right on the CD display.
The default 1 will be used for this example.
FAILSAFE: NO
0 % LEL
0 % LEL
0 % LEL
9
FAILSAFE : YES
0 % LEL
0 % LEL
0 % LEL
10
FAILSAFE: NO
0 % LEL
0 % LEL
0 % LEL
11
W1
0 % LEL
0 % LEL
0 % LEL
12
W1
0 % LEL
0 % LEL
0 % LEL
13