Scott QuadScan II 7400, Руководство по эксплуатации и техническому обслуживанию, Страница: 11 / 121

6 of 116
System Menu Channel Menu Security Menu
Touch Enter Key Touch Enter Key Touch Enter Key
Version 1.# (1) ON/OFF/IHB: ON Security Options
Move through options with
UP/Down Key Move through options with
UP/Down Key Move through options with
UP/Down Key
Adjust Contrast (6) Sensor: 4-20mA (1) Change Password
Inhibit: None/All Full Scale: ### Lock System
Set Local Relays (2) Units: %/PPM / PPB /None
Relay: Common Fail Tag: Six character name
Failsafe: Yes (3) Damping (S): 0 -10
F1 F2 F3 F4 (4)
Zero DB (%FS): 0 – 5
Relay: Common Warn
Inhibit(mA): 2.0 – 20.0
Failsafe: Yes/No Fault(mA): 0.1 – 20.0
W1 W2 W3 W4 (4)
Setup Warning (2)
Relay: Common Alarm Warn Set: ###
Failsafe: Yes/No Warn Reset: ###
A1 A2 A3 A4 (4)
Warn Delay: 0 –10 sec.
Relay: Common Horn Warn Hold: 0 – 7200 sec.
Failsafe: No (3) Warn Latch: Yes/No
W1 A1 ... W4 A4 (4)
Setup Alarm (2)
Press Escape Key then UP key to
advance to next menu Same values available under
Warning
Set Remote Relays (5) Cal Loop Input
Remote Relay 1 – 8 Cal Loop Output
Move through all 8 relays with UP
key. Press ENTER to adjust.
Failsafe: Yes/No
W1 (4)
Press Enter key to step back to
relay 1 - 8
Time: ##:##
Date: ## / ## / ####
Notes:
1. These values are factory set and cannot be adjusted.
2. To access the submenu associated with these parameters, press the ENTER key. To bypass the
parameters, press the UP/DOWN key. Once a submenu value has been programmed, press the ESCAPE
key to go back to the main menu.
3. The common fail relay can only be programmed as failsafe. The common horn relay can only be
programmed as non-failsafe (otherwise the horn enunciator would always be on). Press the ENTER key to
continue with the programming.