Scott QuadScan II 7400, Руководство по эксплуатации и техническому обслуживанию, Страница: 19 / 121

14 of 116
3. Move the hinged section away from the side of the enclosure, disengaging it from the base.
4. Tilt the assembly away from the base enclosure and unplug the ribbon cable from the display circuit board.
Power must be off before removing ribbon cable.
5. On the left side, follow steps 1 – 3. The assembly will then lift clear of the base.
Caution: All circuit board components are now exposed. Extreme care must be taken not to
damage these components.
Using #8 mounting screws or bolts, mount the enclosure to the wall or other suitable structure via the 6
mounting holes in the enclosure.
Use the following steps to attach the assembly to the base:
1. Position the display assembly over the base.
2. On the left side, move the hinge section out from the assembly and make sure it has engaged the hinge rod.
3. Push the top of the hinge section in towards the side of the assembly, locking the left side to the base.
4. Pull the right side of the assembly away from the base and reconnect the ribbon cable.
5. On the right side, follow steps 2 – 4 to complete closing the assembly to the base.
Note: The bottom of the enclosure is pre-drilled for cable entry. Clearance should be allowed for the cables
or conduits when mounting the enclosure. Use all NEMA-4X rated components for cable entry to maintain the
rating of the enclosure.