Initial Start Up
Note: If the ice machine is installed above 2,000 ft.
the bin and evaporator thermostats well need to be
adjusted. Remove the thermostats and adjust
them as shown on the labels of the thermostats.
Return the thermostats to their original positions
after adjustment.
1. Open the hand water shut off valve and check
for leaks at the inlet water valve. Tighten tubing as
needed.
2. Replace the lower access panel.
3. Switch on the electrical power.
4. Switch the ice machine on by rotating the control
knob to the CLEAN position. The water pump
should be operating.
5. Rotate the control knob to the ON position. The
fan in the cabinet should be blowing air in and out
of the front grill.
The ice machine will begin to make ice, but do not
expect much production for the first 3 hours.
Do not adjust ice thickness until the machine has
run for 24 hours.
6. After 24 hours of run time, check the ice
thickness. If needed, adjust thickness by rotating
the ice thickness knob. The best thickness of ice is
1
⁄
2
".
CSWE1
December 1995
Page 5
