Installation:
Proper installation is a necessity, because an
improper installation will cause operational
problems that are NOT covered by any warranty. It
is the customer’s responsibility to contact a
qualified installer.
Proper electrical supply, water supply and floor
drain must be available. An electrical ground is
required.
Do NOT close in the front of the ice maker. The ice
machine requires space at the front base to
discharge warm air.
If required by sanitation codes, seal the cabinet to
the floor with an approved sealant. Legs are not
available for this machine.
Location:
The ice machine must be installed indoors, in a
controlled environment. There must be room to
open the ice machine door and room to move the
ice machine out for service, if needed.
The unit may be built in at the top, sides and back.
Electrical:
Follow all local, state and national codes. If
needed, obtain the services of a licensed
electrician.
1. A separate 115 volt, 15 amp circuit is
recommended. A ground is required.
2. Do not use an extension cord. Have a grounded
outlet installed close enough to the planned
installed position of the ice machine so that the ice
machine’s plug can be plugged in directly.
Cool Air In
Warm Air Out
CSWE1
December 1995
Page 3
