3.
DISPLAY AND NAVIGATION
3.1
DISPLAY INFORMATION
LogBox BLE
has an LCD display with 3 numerical lines of
4 ½ digits to display the current value of all enabled channels, as well as the minimum
and maximum values thereof. At the same time, it is possible to display the current value of up to 3 analog channels and, in a second s
creen, if
enabled, it is possibl
e to display the digital input current value. In addition to channel information,
LogBox BLE
has 7 screens with a variety of
information and features, with 24 symbols that allow for easy information visualization and diagnostics.
Below is an illustratio
n of the display with a descriptive of functionality for each symbol present in it.
Figure 1 – LogBox BLE
Display Information
● : Stays on while the
Bluetooth
interface is available f
or connection or any smartphone is connected. If configured to wake up by keyboard, it
only remains on w
hile the interface is available.
●
: When the d
igital channel is disabled, it remains off. When set to Counter, it remains lit. When configured as "Event Log" or "Logs Control"
remains lit, flashing only when an event is detected at the digital input.
●
: Lights up when the USB cable is connected, turn
s off when the USB cable is disconnected.
●
: It remains lit from the moment it does the first log until the moment it stops registering. In the cases of
"Daily" registration, where the
registering starts and ends every day at a certain time, it will only remain lit within the configured time. Flashes at the time of a log (turns off at
the time of a log a
nd restarts).
●
: Lights up
and stays on when you enter an alarm condition, only going out when a new setting is received, or the alarm status is being
cleared. It indicate
s to the user that there was an alarm at some point.
●
,
,
,
: Light up while the alarm conditions o
f the corresponding channels are satisfied: 1 (analog channel 1), 2 (analog channel 2),
3 (analog channel 3) e 4 (digital channel). When you exit
the alarm condition, the flag is cleared.
●
: Indicates the battery voltage level. This symbol is updated along with the logs interval (even if the device is not registering). However, it
is done at a minimum range of 5 minutes. Thus, if the d
evice is configured to log every 1 second, the battery indicator will only refresh every 5
minutes. If the reg
istering interval is longer than 5 minutes, the battery indicator will update with the same log interval.
●
: Battery over 75 %;
●
: Battery over 50 %;
●
: Battery over 25 %;
●
: Battery below 25 % (provide battery replacement).
●
: Lights up while the "Maximum" information is bei
ng displayed.
●
: Flashes t
o inform you that a valid data packet has been received from one of the available communication interfaces.
●
,
,
,
: Indicates which channels are enabled.
●
: Lights up while the "Minimum" information is bein
g displayed.
●
,
: If the ch
annel unit is set to °F or °C, one of the symbols is lit during channel display. Otherwise, no unit symbol is displayed.
●
: If the clock is set to display in the 12-hour format, the PM symbol lights up when the clock is displayed, and the time is later than 1 p
m.
5/65