Schweitzer Engineering Laboratories SEL-311L, Инструкция по эксплуатации

Страница: 696 / 734

G-6 Setting SEL
OGIC
®
Control Equations Date Code 20010625
SEL-311L Instruction Manual
The Relay Word bits in this example are:
51P Maximum phase current above pickup setting 51PP for phase time-overcurrent
element 51PT (see Figure 3.22)
51G Maximum residual ground current above pickup setting 51GP for residual ground
time-overcurrent element 51GT (see Figure 3.23)
OUT103 Output contact OUT103 is set as a breaker failure trip output (see Output Contacts
in Section 7: Inputs, Outputs, Timers, and Other Control Logic )
When setting ER sees a logical 0 to logical 1 transition, it generates an event report (if the relay
is not already generating a report that encompasses the new transition). The rising edge
operators in the above factory-setting example allow setting ER to see each transition
individually.
Suppose a ground fault occurs and a breaker failure condition finally results. Figure G.1
demonstrates the action of the rising edge operator / on the individual elements in setting ER.
Figure G.1: Result of Rising Edge Operators on Individual Elements in Setting ER
Note in Figure G.1 that setting ER sees three separate rising edges, due to the application of
rising edge operators /. The rising edge operator / in front of a Relay Word bit sees this logical 0
to logical 1 transition as a “rising edge” and the resultant asserts to logical 1 for one processing
interval. The assertions of 51G and 51P are close enough that they will be on the same event
report (generated by 51G asserting first). The assertion of OUT103 for a breaker failure
condition is some appreciable time later and will generate another event report, if the first event
report capture has ended when OUT103 asserts.