Functional description
03.00 | RSS R1/W1 | Assembly and Operating Manual | en | 0889125
33
6.2 RSS-W1
6.2.1 Operation
The transmitter module is not equipped with control elements. It
independently sends a signal every 10 seconds. Anymore if the
state of the input is changed, it immediately sends a signal.
NOTICE
If the red LED WD lights up longer than 0,2 seconds, the radio
contact is disturbed. The adjustment work must be interrupted
and it should be checked what disturbs the radio contact.
6.2.2 Setting switching point on the snap-action switch
■
All pressure chambers of the chuck are depressurized
Ø
Remove the screws (10).
Ø
Screw in screws of size M6 in the threaded holes of the screws
(10).
Ø
Pull out the insert (1) using the M6 screws and unscrew the M6
screws.
Ø
Set the switching point through the bore of the piston (3) using
a hexagon socket wrench.
Wrench size: 1.5 mm
Ø
Screw the insert (1) using the screws (10) onto the chuck.
6.2.3 Checking function
Ø
When the chuck is closed and enters the operating range, LED
D02 lights up after a brief period.
Ø
If the chuck is opened and leaves the operating range, LED D02
should go out after a brief period.
6.2.4 LED - Display
DesignationLED
Meaning
D01 light luminous
The sensor 1 is actuated.The contact of the sensor is closed.
D02 light luminous
The sensor 2 is actuated.The contact of the sensor is closed.
D02 dark luminous
Test mode is activated and battery voltage is existing.
TX
A radiogram is sent just now.
